Frymaster MF90 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
2-2
2.1 General (cont.)
The used oil may be drained by gravity from the fryer into the filter pan, or removed from the fryer
by use of a suction/return hose, according to model. The oil is pumped back into the fryer vessel
using the same suction/return hose.
Oil or shortening is filtered through replaceable filter paper. Filter powder, which enhances the
filtering process, is distributed over the paper prior to filtering.
All units are shipped completely assembled with accessories packed inside the frypots. All units are
adjusted, tested and inspected at the factory before shipment.
CAUTION
The on-site supervisor is responsible for ensuring that operators are made aware of
the inherent dangers of operating a hot oil filter system, particularly the aspects of
oil filtration, and draining/cleaning procedures.
A 7-amp (115V-domestic), or 5-amp (230V-international) circuit breaker installed on the filter unit
switches the power OFF if an overload occurs.
NOTE: If the circuit breaker is triggered, depress the reset button to activate the circuit after the
failure has been detected and repaired.
2.2 Rating Plate
Information on the rating plate includes model and serial numbers, as well as electrical requirements.
Have the rating plate information handy when communicating with the factory about a unit or
requesting special parts or information. Without this information, proper identification of the unit
cannot be confirmed.
2.3 Pre-Installation
NOTE: Failure to use qualified service personnel will void the Dean warranty.
A. Standards: Use of this filter unit must be in accordance with all applicable state and local
codes.
B. Electrical Connections: Domestic MF90 filter units require a 115V 60 Hz., 15 amp electrical
supply. Units are equipped with a grounded male receptacle for use with a flexible six-foot,
16-3 SJT power cord set. If an extension cord is required, it must be a three-conductor,
grounded power cord of at least 16 gauge.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Comments to this Manuals

No comments